Loading...

Cutting the duct-tape form into pattern pieces | Lucy's Corsetry

66,185 views

Loading...

Loading...

Transcript

The interactive transcript could not be loaded.

Loading...

Loading...

Rating is available when the video has been rented.
This feature is not available right now. Please try again later.
Published on Sep 1, 2011

How to cut up your duct-tape corset form into basic, vertical flat pattern pieces, and then how to figure out which pattern pieces to modify (to reduce the waist area) and how much to modify each piece.

There are 3 different methods for modifying the pieces:
a) Taking off the same amount from each of your "workable" sides (all sides except center front and center back)
b) Only reducing the panels that you deem most important (for instance, if you need more bum room, only widen the back panels at the bottom)
c) Reducing every pattern piece based on the size of each piece and it's % of the total circumference:
http://foundationsrevealed.com/free-a...

After cutting your pattern pieces from the duct tape form, transfer the pieces onto large paper or bristol board and modify them as you wish. Then create your new, "workable" pattern pieces from paper, cloth, cardboard etc. and create your mockup to test the fit in fabric!

Keep up with me elsewhere!
★ Website/ blog: http://lucycorsetry.com
★ Facebook: https://www.facebook.com/bishonenrancher
★ Twitter: https://twitter.com/bishonenrancher
★ Tumblr: http://lucy-corsetry.tumblr.com
★ Pinterest: http://www.pinterest.com/bishonenranc...
★ Instagram: http://instagram.com/lucycorsetry
★ And of course, subscribe here on Youtube: http://www.youtube.com/user/bishonenr...

Loading...

Advertisement
When autoplay is enabled, a suggested video will automatically play next.

Up next


to add this to Watch Later

Add to

Loading playlists...