YouTube home National Registration Day
Upload

Loading...

Build an Ellsworth jig

59,269 views

Loading...

Loading...

Transcript

The interactive transcript could not be loaded.

Loading...

Loading...

Rating is available when the video has been rented.
This feature is not available right now. Please try again later.
Published on May 6, 2012

When building the jig there are three main points to focus on. #1 a 45% angle for jig post to where gouge sits #2 the three holes drilled in the block must all be aligned and centered at corresponding angles #3 the pocket inline with center of grinding wheel. as far as the length of jig post used this can vary somewhat, but by raising or lowering the pocket slightly a sweet spot can be achieved easily. the overall shape of the block does not matter except for allowing clearance from the grinding wheel. personally i could not grind the precise angles this jig allows me to get effortlessly on my gouges without it.

  • Category

  • License

    • Standard YouTube License

Loading...

When autoplay is enabled, a suggested video will automatically play next.

Up next


to add this to Watch Later

Add to

Loading playlists...