Loading...

OrangeRx RX3S V2 Stabilizer - Delta Setup

23,530 views

Loading...

Loading...

Transcript

The interactive transcript could not be loaded.

Loading...

Loading...

Rating is available when the video has been rented.
This feature is not available right now. Please try again later.
Published on Mar 6, 2013

How to setup a delta wing with the OrangeRx V2 Stabilizer unit. This unit has onboard delta mixing, so start off by disabling any delta mixing that you have programmed.

Link to stabilizer: http://www.hobbyking.com/hobbyking/st...

https://sites.google.com/site/project...

- Rx: Using male-to-male servo wires, hook up the Elevator and Aileron controls from your Rx to the stabilization unit's Ele and Aile ports

- Stabilizer: Plug in your right control surface to Ele and your left control surface to Ail-L (right and left control surfaces as you look at the plane from the nose). Then flip the dip switches to the left for Ail, Ele, and Delta. [if your servos are lying down (mine are upright), you need to leave both ELE and AIL L set to NORMAL, rather than reversing them - thanks Flash5Cartooning!]

- Tx: Reverse your elevator output.

That's it! Hope this helps. Let me know what questions you have.

(I think that this should work for all transmitters, but I am using a Dx7se and can't verify this!)

Loading...

Advertisement
When autoplay is enabled, a suggested video will automatically play next.

Up next


to add this to Watch Later

Add to

Loading playlists...