 Okay, lady. What's this? Okay? I'm testing out these kind of interesting headers We got a request to have solderless headers in the store And so if you look these look just like pin headers, but you see there's like this little like notch hole in the shorter pin This the way this design is that you could kind of like shove it into some Holes in a breakout board and they would make contact using like a cold contact not a hot solder contact So you can do some quick prototyping and then you could remove them if you wanted to but maybe you know for Times when you don't want to solder headers in so the only thing I notice is that you need to you know kind of it's a little tricky You definitely want to have You know the headers the right length so let's break off piece and see if I can do this live demo Okay, and then you want to get like a good grip on the headers. I'm using like these pliers Like The pliers to press down flat and There you go. We did it and then I actually checked this is like you know It's pretty solid and it's got continuity So the only trick is like you really need to use pliers or vice to really get good Leverage because you have to push them in but it's okay that this one is like not fully pushed in you can like give it a little bit more of a Yank if you want You just adjust it. So, you know, it's not easier than soldering, but you don't need a soldering iron. Anyways, these look good So I'll put them in the shop