Loading...

Installation of a Trailer Hitch on a 2006 Nissan Murano - etrailer.com

2,830 views

Loading...

Loading...

Transcript

The interactive transcript could not be loaded.

Loading...

Loading...

Rating is available when the video has been rented.
This feature is not available right now. Please try again later.
Published on Sep 20, 2010

http://www.etrailer.com/hitch-2006_Ni...

Today on this 2006 Nissan Murano we are going to be installing Curt hitch part number 13571. Before we get started installing our trailer hitch we need to do a couple of things in preparation. We first need to lower the exhaust system down. This vehicle has a dual exhaust system so we do need to remove the hangers from both sides of the vehicle. There are two on the driver side and one over on the passenger side outboard frame rail. The hanger on the passenger side is bolted to the side of the frame so we are going to unbolt it to lower it down. Over on the driver side we have just got some standard rubber hangers. To remove these we are going to spray down the studs of the hangers with a spray lubricant and then we can take a set of pliers or a pry bar and separate the two. If you still do not have enough working room underneath the vehicle it might be a good idea to remove the fourth exhaust hanger at the forward side of the vehicle almost even with the axle. 00:56

Note: Videos are provided as a guide only. Refer to manufacturer installation instructions and specs for complete information.

Loading...

When autoplay is enabled, a suggested video will automatically play next.

Up next


to add this to Watch Later

Add to

Loading playlists...