 In this pouch is the wireless mic micropones So you have the batteries And we have both The wireless receiver You see this at the back There is actually a Transmeter, so this is a transmitter For the wireless microphone And this is the receiver So For the transmitter You connect to a Micro... to a microphone The clip on mic It looks like this So this clip on mic You basically plug it in here Screw it in As tight as you can And you will be able to clip this on to the speaker Usually on its color And this will be used to record His voice To open the battery hatch There's two buttons for the side Just press, just squeeze it And pull out You have battery compartment The on-off switch is over here Just press and hold And the power will come on So there's the transmitter The receiver, this is the receiver The receiver is used to Receive audio signal From the transmitter Same logic Just press and hold Press the sides Battery compartment opens And you can slide the batteries To the on You plug this Plug it in With this cable And screw it in Right And the other side There's an XLR connector Which is a 3-pin connector This one connects to the audio interface This is the Yamaha C1 So you plug this into The back Usually I will use the first interface Mine one Plug it in and press straight forward Just make sure the groove Is facing the top Just plug it in Okay It only goes in one way So this will be used To record the audio You're going to use close-miking with this one Basically close-miking means the Microphone is very close to the speaker This will pick up the best quality audio If you don't, you'll find this too much of a hassle to set up So you can ignore the audio interface as well as The wireless microphone So just use the camera's microphone to record So the Q2HD itself has a pretty good microphone over here So you can use that To record the audio as well