 Hi, my name is Andrew Varga and I'm with Razor Back Off-Road and today we're very excited to feature our new rock sliders for the Polaris General. And I'll just kind of go over some of the things I'll be included in the kit that we will send you. When you receive your sliders from Razor Back Off-Road, we include all the hardware and components to make it a direct bolt onto the machine. There'll be no drilling required or anything like that. It's a very easy install. Some of the tools that you'll need for the installation will be a 10 millimeter socket and extension. And the extension just makes it a lot easier for the installation as you'll see here in a minute. A ratchet and like I said, we include all the hardware and you'll need a T40 Torx bit to take off the existing hardware on the machine. And so how we're going to start is we're actually going to start with the T40 Torx bit and we're going to go ahead and take off the existing hardware off the machine. So I'll go ahead and do that. So what we're going to do is there's three existing bolts here on the machine and that's what we're going to remove first before we install the rock slider. So go ahead and do that. So once you remove those three existing bolts off the machine, you're going to go ahead and grab three bolts that we provided you and also grab the 10 millimeter socket, the extension, and the ratchet. So I just wanted to talk about kind of the design of these rock sliders. As you can see this has two bent tabs on these lower brackets right here. And what these are intended for is it's going to basically help you align the slider onto the machine. As you can see it'll go right into the pre-existing holes that are from the manufacturer on the machine. So these will slide right in there and then these bolt holes will line up with the previous bolt holes that you just removed the hardware from. So I'll go ahead and show that. So as you'll see it literally will slide right into place and it almost holds itself. I'll just hold the top with my right hand like so and I'll start with this middle kind of this back lower bracket and I'll just start and just start with hand tightening it on onto onto the machine. And once you kind of get it started that's what I was talking about before where you use the socket and the extension and you can use that to finish. Just get it you know tight enough to where it'll hold itself up there and as you can see once you kind of get that one started it'll pretty much hold itself. Go ahead and grab the other hardware and put in the other two bolts as well. Okay just hand tight. I'll do this one. On the front one if you look kind of right through the top here you can kind of see the hole and that's why this extension is kind of handy because then you can you can guide that bolt right into the pre-existing hole here. Okay and then once you have that grab your socket and go ahead and tighten tighten the bolt pretty good onto the machine. Okay so once you have all the bolts tightened onto this side you're going to go ahead and do the exact same thing on the other side. It's a as you can see it's a very quick install and it should take you no time to get this onto your machine and get you back up and running. This will complete the installation of the rock sliders for the Polaris General and if you haven't yet please visit our website at razorbackoffroad.com and subscribe to our YouTube channel and other than that we'll see you out on the trail.