Loading...

AUTOMATIC SEEDING MACHINE - MÁY GIEO HẠT TỰ ĐỘNG ( ASM 01 )

21,686 views

Loading...

Loading...

Loading...

Rating is available when the video has been rented.
This feature is not available right now. Please try again later.
Published on Mar 13, 2010

AUTOMATIC SEEDING MACHINE
Principle of operation
• The entire machine works based on the source of vapor compression
• Operating cycle is electrically operated, the setup program analog electronic circuits. Including
• Pressure compressor with automatic pressure regulator.
• Source vapor pressure is leaded to the splitting of water and mixed with oil lubrication to maintain steam ben.
• Through the air contact to the machine .
• The entire operation with analog programs is leaded through many solenoids.
• Take up the seeds by needle, the vacuum created by pettoly principle is always
in the tube in order to keep the seeds inside the tube.
• The entire operation of the machine can be adjusted, to achieve the highest
priority.
• therefore, it has superior characteristics compare to other machines.
• seeds fell right into the center hole of tray
• Automatic needle cleaning two times during every activity cycle to prevent dust
blockage.
MANUAL MACHINE
buttons on the panel (main)
1. Air pressure source
2. Seeds drop
3 . Particle vacuum suction
4 . Functions to work
5 . Speed
6 . Vibration
7. Seed withdraw
8. Clean needles by hand
9 . Automatic needle cleaning
AIR COMPRESSOR OPERATION
• Pump of pressure was put away 10 to 15 meters distance, to avoid noise.
• Pressure pump works with pressure equalizer, ( 8kgf stop running and 5 kgf the pump begin running.)
CALIBRATION BALANCE MACHINE
• It is essential to adjust your machine balance before running.
• Place seeds into the seed tray
• Turn on the button vibration ( 6 )
• when you can see the seed was mixxing and disturbances, that is ok .
• open contact working ( 4)
• reduce the smallest speed ( 5 )
• shift needle to seed trough into position and turn the button ( 3 ) to take up seeds .
• If the seeds are attached to the pointy end of the needle steadily, that is the machine is working finely.
then move the location of the bar higher and turn needle buttons ( 2 )
• when you see the seed is to be dropped,
• Then turn on button ( 9 ) when you see it is clean by air press pray.
• All buttons can be locked tightly.
BEGIN RUNNING MACHINE
• Turn off buton ( 3)
• Move the tube into the lowest position at the beginning of the cycle,
• Open source air ( 1 )
• Move the tray into the position
• Turn on the contact working ( 4)
• Observe the operation of the machine and adjust it to a more suitable mode.
• Then Turn speed on higher ( 5 ).
MAINTENANCE INSTRUCTIONS
• Regular maintenance for the pump need to be considered.
• Fill lubricant oil ( No 40 ) on the calibrated line.
• Clean machine in dry conditions
• prevent moisture and wetness
• Turn off air source and electricity after the operation

Wish you all the success and highest results with this advanced seeding machine.

Contact : 84633651588 - 84938454435
Mail : anhtrile@gmail.com

Loading...

When autoplay is enabled, a suggested video will automatically play next.

Up next


to add this to Watch Later

Add to

Loading playlists...