 Hey there guys Oh yeah There we go, the 12.5 volts You can see what it says We got this going on here Engine Engine 12 kilohertz That's a little boost DC boost converter circuit And at the minute was set up at a 250 volt range And this piece of Lovely piece of kit from China Just over 150 volts anyway, so it works I've got a one milli Henry inductor I Think that's a 220 ohm 220 micro farad electrolytic there as a 400 volt 100 nano farad What it says down there on the side is it? 100 micro farad, 400 volt And that's MGE 13 130009 NPN transistor There's a little 2222 transistor down there I think I can't remember what this 560 ohm resistor I've been playing with this all day I started off playing with it just over here On this part of the board Every now and then it would work And it wouldn't work And some of the pin connectors are dodgy But moved it over here Having no problems since So I've tried Different inductors This one's actually got a little A little rod that goes in it It's quite good when you put it on it sucks it through Yeah, I lost it again There we go I tried that Tried plugging it into the board Not very good Makes a bit of squeal when you put it on wires And try plugging it in Did this one I've just tried loads of different inductors Just tried to see what it would do A little baby one here Tried that as well Tried lots of different capacitors You can see my bench Put the light up We've got all sorts over it Been the Pastors trying to dig out Wow Pastors there LEDs and just general Oh, my life Proper little play with this circuit But I'm still trying to find something That can actually do meaningful We can put an LED on But that's not I need to try and figure this out Better to get it to do something better I know if I Can get a bit more amperage Draw more power I can put a 330 mic in there And then we start drawing About 400 milliamps of power on the power supply At the minute Just put it wisely With a 220 That's what we got I'm using 12.6 volts Because that's what I'm going to be having up for the batteries And that's what I want to start doing I want to start running as much as I can from the batteries I've ordered I've got like a What did I do with that last night I've got a 10 amp step down There I've got a 100 watt step up converter On its way And I've got another 600 watt step up converter On its way After watching What his name is He's spoken to me today On YouTube, Jim, someone Another After watching his Testing of one of the Step up converters, I thought that would be pretty good I'll go for that I'll circuit myself Now This is like a note of a copy of Ludic Science With Just a few changes Because I've been faffing about But I think he's probably about About right I've got the better one out of mine than his anyway So Yeah, I just thought I'd share that I'm waiting for These For the cube Partly finished So there look Just got a few more LEDs that's needed for it And they're sending out a whole new kit So I've got to wait about Three to four weeks And that's dropped down I suppose that's because I've put the I can get that to drop down Just by putting the LED on And the LEDs on Take it off and Start climbing back up again It's quite funny to watch the waveform Take the shape again as well Anyway Cheers watching guys