Loading...

Strengthening a 3D Powder Print with XTC-3D Epoxy Resin Coating

27,925 views

Loading...

Loading...

Rating is available when the video has been rented.
This feature is not available right now. Please try again later.
Published on Dec 18, 2014

Powder parts infused with thinned XTC-3D epoxy resin are strong and flexible.

In this video, we demonstrate how to properly thin XTC-3D for infusion of powder printed 3D pieces.

XTC-3D® is a protective coating for smoothing and finishing 3D printed parts. Two liquids are mixed together and brushed onto any 3D print. Coating self-levels and wets out uniformly without leaving brush strokes. Working time is 10 minutes and cure time is about 4 hours (depending on mass and temperature). XTC-3D® cures to a hard, impact resistant coating that can be sanded, primed and painted. Adding colors and metal effects is easy.

Inexpensive to Use: 1 oz covers 100+ square inches.

90% Time & Labor Savings: XTC-3D® fills in 3D print striations and creates a smooth, high gloss finish. The need to post finish is almost eliminated.

Coat any 3D Print Surface: XTC-3D® can be applied to both SLA and SLS prints. It works with PLA, ABS, Laywoo, Powder Printed Parts and other rigid media. It also can be used to coat EPS, EPDM and urethane foam as well as wood, plaster, fabric, cardboard and paper.

XTC-3D® does not contain VOC's, phthalates or phosphates.

Make It Now! with Smooth-On
http://www.smooth-on.com/
http://www.facebook.com/SmoothOn
http://twitter.com/SmoothOn
http://www.google.com/+smoothon

-~-~~-~~~-~~-~-
Adult Supervision Required
Keep Out Of Reach Of Children
-~-~~-~~~-~~-~-

Loading...

When autoplay is enabled, a suggested video will automatically play next.

Up next


to add this to Watch Later

Add to

Loading playlists...