 Hi there, so we are ready to do our next coat of art resin on our wood tray So what I'm going to do now is I took a piece of acetate here And I cut out a small piece to fit over the hole in the wood So what I'm going to do is tape it on to create a base for our first layer and you can see I also taped around the edges Here on the underside so to protect it from any drips when we resin the top side Okay, so I'm just going to tape this guy on And we're going to flip. I'm just going to give it a quick spray with the dust spray Now I've got my resin here in its baby bath, so I'm just going to pull this out again Okay, so we're going to do a little bit more than a shot glass Of each one because I'm going to do again with a gloved hand I'm going to cover the top, but I'm also going to need enough for my first base layer And there we go Stir and stir and stir and stir in three minutes scraping the bottoms and sides Okay, great So I've stirred my art resin and I'm ready now to do a very thin coat with my gloved fingers And it's totally normal if you have to sand and resin and sand and resin a few times Especially with a natural material like wood Okay, so now that this is coated in a nice thin layer of art resin I'm ready to pour my base layer in the hole here So I'm going to do like a really thin layer like an eighth of an inch Just because I don't want any bubbles. We've got our acetate below to contain the resin so just again to err on the side of the caution because the hole actually goes underneath where I can't see so I'm just Tilting it a bit just to make sure that the resin Is hitting all of those spots there and then it's going to self level and I'm just going to Torch out the bubbles Okay, so I'm just going to rest them again on these little Lifters here. We're going to leave it for 24 hours And then we're going to pour our next hope and we'll start building up our layers So we're ready now to start our first layer of building up this the resin in the hole here Yeah, it turned out really well and now we're just going to pour really thin a succession of really thin coats Torch the bubbles out and we're going to do it every two hours just to build up the layer of resin In the hole here. We're going to end up sanding this entire thing down again Just to make our resin in the hole a flush to make this nice and flat, so I'm not too worried about the rest of it right now Pour it in try not to let it run too much up the sides here Okay Looking good. I'm going to get my torch here. I'm going to torch out these bubbles Okay, so then we're going to cover this we're going to wait two hours And then we're going to pour another thin letter layer and we're just make it going and going until we're Fill the hole Okay, so we're ready to put our very last coat of resin over the hole in our tray here And once this cures tomorrow, we're going to sand down the the tray to make it completely level And then we're going to put our final coat of resin on. Okay, so here goes the last coat Okay, perfect. So I'm just going to torch it one more time to get those bubbles out Awesome, it looks like glass beautiful. Okay, so we're just going to cover this up and tomorrow we're going to sand. See you then