 Hey everyone, Drew with GeoArm and I am back to talk to you about the Geo Alarm Control Panel and how to set up the Swinger Shutdown. What a Swinger Shutdown is, is a setting that prevents the same sensor from triggering the alarm over and over and over again. Now you can set the Swinger Shutdown between 1 and 5, so one time would mean that sensor can only trigger one time and then it's not going to do it again so you don't get, you know, recurring alarms until you disarm and rearm the system. You could set it to 2, 3, 4, 5, 5 is the max. So let's go ahead and get into programming here. And to your master passcode, line is 1, 2, 3, 4, you set that up at the time that you configure your panel. Select security. Okay, Swinger Shutdown is right up here in the top left hand corner, or right hand corner, I'm sorry. It's set to 2, inherently, that's just the factory setting for it. You can bring it down to 1, or you can bring it all the way up to 5, or actually 6, I apologize. I said 5 previously, but it is 6. So I'm going to set it back to 2, which is the factory setting. But remember, 1 to 6 times you can set the Swinger Shutdown and that just prevents the same sensor from going off over and over and over again. If you guys have any questions or any comments, please leave them below. Other than that, take care and have a great day. Please like and subscribe to our page for helpful programming and installation videos, product reviews, monitoring, products, and more. Visit www.gawarm.com or call 877-443-6276. That's www.g-e-o-a-r-m.com or 877-443-6276. GEOARM, the worldwide leader in DIY security.