Loading...

PART 2: HOW TO MAKE A MONEY LEI stories and tips

155,447 views

Loading...

Loading...

Transcript

The interactive transcript could not be loaded.

Loading...

Loading...

Rating is available when the video has been rented.
This feature is not available right now. Please try again later.
Published on May 13, 2012

WATCH PART 1: Instructions
http://www.youtube.com/watch?v=AjBOSI...

TIPS:
- If bead holes are to small and/or ribbon to wide. Make a needle out of thin wire.
- You can follow the first fold by where the white boarder ends at the back of the bill.
- It's much easier to secure the loop end to a chair or your foot to insure a tight lei.
-Tie a knot after bill to insure security. HOWEVER a tight lei from the pushing of a bead can be enough for a secure bill.
- One FULL lei with spacers can be 50+ bills. depends on how large you space the bills out and how long you want the lei
- Tape multiple panels if ends can't meet nicely. IT DOESN'T SHOW
- Hot Glued bills can be peeled off slowly
- Stubborn hot glue parts can be soaked in water and CAREFULLY peeled off [can cause holes if not careful]
-To take out the fold creases for spending. Soak the bill in water, then iron. careful to not put iron to high. it can burn.

Loading...

When autoplay is enabled, a suggested video will automatically play next.

Up next


to add this to Watch Later

Add to

Loading playlists...