 Today I'm going to show you how to install the new Roto Riot Edition AGO1 Gimbal into your RadioMaster TX16S. You want to pull out your battery as well as the module bay cover, pull the grips off of each side of the radio. Next we want to remove these two screws in the top using our 2.5 millimeter hex driver. We'll take our 2 millimeter hex driver and we need to remove four screws. From there we can carefully remove the back cover of the radio. There might be some wires connected to the back. Just make sure you unplug that wire. The easiest way to tell which direction to install the gimbal is that the wires coming off of the gimbal need to go on the outside edge of the radio. On the gimbal there's four silver screws at each corner that we're going to remove with our screwdriver. And then we need to unplug the gimbal here and we should be able to pull the gimbal out. And we're just going to do the same steps in reverse. So we're going to take our gimbal, we're going to drop it in there, we're going to take our four screws, put those back into place, run these wires and look at that. We feel great. Subscribe to Roto Riot.