Review of MAGIGOO Bed Adhesive and Geeetech Gradient Color PLA





The interactive transcript could not be loaded.


Rating is available when the video has been rented.
This feature is not available right now. Please try again later.
Published on May 12, 2017

Hi Guys!

In preparation for Bay Area Maker Faire I wanted to print some more interesting maker coins. So I reached out to Geeetech and purchased a roll of their Color Gradient PLA. It prints like a dream! My only wish is that the color changes would be faster and repeated several times throughout the spool instead of gradual single color change throughout the entire length of the spool.

Magigoo contacted me and offered to send me a free sample of their Bed Adhesive. It worked amazingly well!!! It sure beats the Elmers washable school glue I normally use. I have been using it now for almost a week, and it works great!!! My only advise is to wait till the heat from the bed fully dries the adhesive. If you print too soon, your prints will stick too good. Give it about 5 minutes and you will be super happy with the results.

If you are interested in Magigoo, here is the web site: https://magigoo.com/

If you are interested in the Color Gradient PLA from Geeetech, you can find the link here: https://www.geeetech.com/gradient-col...

Thank you very much for watching!!!

Check out my website www.jimmyshawstidbits.com

Affiliate Links:
Amazon USA: http://amzn.to/2owkFMX
Geeetech: http://www.geeetech.com/?cID=11254

$20 off coupon code for Geeetech MeCreator2: BMC2FJSYT20

Follow me on Twitter @JShawsTidbits
Like me on Facebook www.facebook.com/JimmyShawsTidbits
Email me JimmyShawsTidbits@gmail.com
Please share my channel www.youtube.com/c/JimmyShawsTidbits1

Please consider becoming a Patreon Supporter. $1 a month would help offset the cost of filament: https://www.patreon.com/JimmyShawsTid...


When autoplay is enabled, a suggested video will automatically play next.

Up next

to add this to Watch Later

Add to

Loading playlists...