Loading...

2000 Subaru Outback - EJ251 Valve Cover Gasket Replacement

41,578 views

Loading...

Loading...

Transcript

The interactive transcript could not be loaded.

Loading...

Loading...

Rating is available when the video has been rented.
This feature is not available right now. Please try again later.
Published on Jan 29, 2012

2000 Subaru Legacy Outback valve cover gasket removal and installation. Took approx 3 hours, including a spark plug change.

Procedures:
Passenger Side-
Remove air duct and resonators.
Remove spark plug cables.
Remove valve cover and all old gaskets.
Clean valve cover and re-install with all new gaskets.

Driver Side -
Remove battery
Remove Washer fluid reservoir.
Remove oil reservoir.
Remove valve cover and all old gaskets.
Clean valve cover and re-install with all new gaskets.

Install everything else in reverse order.

Note:
Torque is 3.6 ft lbs so be wary of over tightening.
Need a 10mm wrench to get into tight spots, ratchet is too big.

Loading...

When autoplay is enabled, a suggested video will automatically play next.

Up next


to add this to Watch Later

Add to

Loading playlists...