 Hey guys Chris Burch here entrepreneur strategies create DC. We're behind the scenes again in the print shop and Today, I just wanted to quickly go over printing banners What you're gonna need is obviously some form of a printer. We're actually using our smaller machine today. It's a rolling 300 It's a UV printer print bright bright high quality vibrant graphics This is going to be a banner that's actually going in a parade tomorrow So we're printing four of these today, but what you're going to need to get started is you're going to need the printer a Roll of batter material. We're using on this one. We're using a 13 ounce vinyl banner You're going to need a straight razor You're going to need some banner tape and then you're going to need a grommet punch So if you're ready to go behind the scenes with me, let's get started right now And then it'll measure the sheet the the the width of the sheet and then we can take over here Our file is loaded on the computer We have it all set and now what it's going to do is going to rip the job and Then it'll start running This banner. All right, so we have our full-color banner Fully printed Figure that wouldn't bore you guys with the fact of watching the print. It took about Probably about 15 minutes to run this. It's a two foot by six foot banner And then what we're going to have to do is you see you have all this extra white space So we're going to take our straight razor And we're just going to trim a border and if you see here I'm purposely leaving About a one inch border And I'm going to show you why let me trim the other three sides You've got one more cut down this last side and You could use something something like a t-square Just to make it straight but For these purposes is not necessary So now you see we have an even white border all the way around the whole banner And the reason why Is we're gonna flip it over So now we're on the back side And if you've noticed on banners, you might not have noticed there's a usually a seam along the edge So we're going to take as our banner tape. This is just a double-sided Adhesive tape And we're going to lay that down the edge Okay I'm going to trim that off and then you're going to peel The double-sided tape you're going to peel the backing off of the tape So then all you'll be left with is the adhesive and the reason you are going to need this Layer so now you have that adhesive layer and all we're going to do is just fold it over and That creates a seam All right, so now you have for one one you have the durability Now that this banner is going to be double layered around the edge So I'm going to go ahead and tape the all the three sides and then I'll show you how we do the grommet punch All right, so we're all taped up We got seams around all four sides and then with the last step to complete the banner is We're going to put in these little metal grommets And for that we have a manual grommet punch You place the grommet down Put the banner in between And then you can just punch down So now you have a full-color banner We're going to put these grommets all the way around all sides and we're actually because it's the length of this banner We're actually going to put them in the middle as well so they can hang it on this float in this This parade that they're doing tomorrow So as simple as that seems there are multiple steps Do me a favor if this was entertaining it brought value to learning how banners are produced and how we produce them here Do me a favor smash that like button give me a thumbs up Love to hear from you guys post in the comments below and I will see you soon