Loading...

Machining bearing seat in the pipe by lathe 1K62 and dial inside micrometre

1,823 views

Loading...

Loading...

Loading...

Rating is available when the video has been rented.
This feature is not available right now. Please try again later.
Published on Mar 3, 2012

I makeing the belt conveyer rolls. At roll either end is bearing seat. For accuracy chech I use dial gauge micrometre Machine is to SET for much workpiece machining. Speed= 400RPM, feed= 0,195mm/rev, "chip"= 2mm. Finich cut: Speed= 630RPM, feed= 0,097mm/rev, "chip"= cut #1= 0,25mm cut #2= 0.03mm

Loading...

When autoplay is enabled, a suggested video will automatically play next.

Up next


to add this to Watch Later

Add to

Loading playlists...