Loading...

HR Slitting Line_IDH Ltd.wmv

25,913 views

Loading...

Loading...

Transcript

The interactive transcript could not be loaded.

Loading...

Loading...

Rating is available when the video has been rented.
This feature is not available right now. Please try again later.
Uploaded on Oct 10, 2010

DAEHYUN's SLITTER LINE for Heavy Gauges is used to produce the main materials for Piping and Forming operation.
DOUBLE CONE TYPE UNCOILER has three steps for the efficient loading of the coils of which the inside diameter is 508mm, 610mm, 762mm. Since the head of heavy gauge coils is poor, CROP SHEAR cuts off the poor coil head and feeds the coil into Slitter Stand. Adjust Separator and Bridle Roll, and start rewinding.
It is very important to minimize Camber tolerance in heavy guage coils. DAEHYUN manufactures Slitter arbor and knives precisely to minimize Camber tolerance, then does test-run and inspection sufficiently before shipment. Two sets of SCRAP WINDER remove the scraps.
DAEHYUN's Slitter Line for heavy gauge can be operated at the maximum line speed of 200M/min and DAEHYUN designs and manufactures Slitter Stand for 12.7mm and 16mm thickness coils. RECOILER is designed and manufactured not to cause Reel Mark inside the coils, and SEPARATOR is installed to reduce SKELP TELESCOPE while rewinding.
With the Spare Slitter Stand to set the knives for the next operation, the users improve the productivity and save operation time by adjusting the knives on Spare Slitter Stand.




Materials Hot Rolled Steel
Picked & oiled Steel
Hot-Dip Galvanized Steel




Materials Specification Coil Thickness : 1.2~6.4/12.7mm
Coil Width : 600~1,550/1,830mm
Coil Inner Dia. : 508/610/762mm
Coil Outer Dia. : Max. 2,200mm
Coil Weight : Max. 30Ton




Line Specification Line Speed : Max. 150 or 200mpm
Cutting Type : Pull & Drive Type

Loading...


to add this to Watch Later

Add to

Loading playlists...