 Hey everyone Drew with GeoArm and I am back to talk to you about the 2GIG GC2 series panels which includes the GC2 this one and the GC2e which is the encrypted version. All we're going to be doing here is just locating firmware so this is a super simple easy video. What we're going to do is we're going to go into security then we're going to hit menu. When you get into menu go ahead and hit toolbox and then you're going to enter your installer code. Mine is the factory code of 1561 that should get you into the programming menu. When you get into the programming menu you're going to go ahead and you'll see a bunch of icons here. These don't apply to what we're doing so go ahead and hit the right arrow down on the bottom right one time. Now we'll see a new series of menus pop up. You're going to go ahead and you're going to hit version. When you hit version it should give you the firmware version that your panel is operating on. Mine is operating on 1.13 right now it's an older firmware version but that's how you locate the firmware version so all you do once again is get into version once you're into that menu and it'll say it right there so go ahead and document that and then you're going to go ahead and hit the back all the way until you're out of programming. Once you're out of programming you're good to go but that is how you locate the firmware for the 2GIG GC2 series panels the e and the regular. If you guys have any questions or any comments please leave them below but other than that take care and have a great day. Make sure to subscribe to our YouTube page and click the show more tab underneath the video where you can view valuable links pertaining to this product similar how-to videos and our low-cost no contract alarm monitoring services.