Loading...

92436 | Power-TEC Weld and Slide Dent Puller

5,997 views

Loading...

Loading...

Transcript

The interactive transcript could not be loaded.

Loading...

Rating is available when the video has been rented.
This feature is not available right now. Please try again later.
Published on Jul 21, 2015

•Part of the Power-TEC panel repair range
•Slide hammer and resistance welder combined in one unit.
•Lightweight. CE Certificated

•Simply weld to the panel then use the internal slide hammer to pull the dent out. Replacement copper welding tip available - Part No 91001

•Twist 90 degrees to break weld
•Earth Electrode housed in the same unit.

•Traditionally dent pullers meant that a series of holes was drilled in the sheet metal to make the repair but that weakened the panel and the holes had to be filled. Then stud welding became popular but was time consuming and meant grinding off any remaining stud material after the pulling was completed. Now Power-TEC takes dent pulling to the next stage with its new Weld & Slide dent puller (part no 92436).

•This is a slide hammer and resistance welder in one instrument; it is simply pressed onto the area to be repaired — the earthing rod and welding shaft are spring loaded — a button is pressed which welds the tip to the metal, and the instrument is pulled back along the shaft to complete the slide hammer action. Turn ninety degrees to break the weld, move along the dent and weld again. Each welding action tightens and shrinks the sheet metal before it is pulled back.

•As the instrument provides the earth and welding tip circuit in a small, very focused area, it is ideal for the repair of electric and hybrid vehicles.

•Professional kit designed to save time and available now from your Power-TEC supplier at a typical price of just £880.00 plus VAT.

•Further details at www.power-tec.co.uk or call 01926 815000.

Loading...

When autoplay is enabled, a suggested video will automatically play next.

Up next


to add this to Watch Later

Add to

Loading playlists...