Loading...

Installing a Servo on an RC Car: Dremel Driver

11,722 views

Loading...

Loading...

Transcript

The interactive transcript could not be loaded.

Loading...

Loading...

Rating is available when the video has been rented.
This feature is not available right now. Please try again later.
Published on Nov 24, 2008

See how to install a servo on an RC car using the Dremel Driver

Because the Dremel Driver is lightweight, ergonomic, and provides a trigger with a moto break, you can easily control a tiny #1 sized screw. For this project we're using the Dremel Driver and the suitable driver bit. First attach the driver bit to your Dremel Driver in its magnetic bit holder to hold your bid securely in place. Select the reverse speed on the trigger located on the front underside of the tool. Gently remove the screw from the servo. The slim nose design provides excellent access to tight areas by allowing you to see exactly what you're doing. Then change the driver direction to forward put the servo and screws back in place and slightly squeeze. The precise action of the Dremel Driver will allow you to get them into place without the worry of stripping the screw.

Loading...

When autoplay is enabled, a suggested video will automatically play next.

Up next


to add this to Watch Later

Add to

Loading playlists...