Loading...

Mike Makes an Adjustable Height Workbench (Lifting Mechanism)

136,672 views

Loading...

Loading...

Transcript

The interactive transcript could not be loaded.

Loading...

Rating is available when the video has been rented.
This feature is not available right now. Please try again later.
Published on Jul 19, 2015

I'm building an adjustable height workbench but I needed a lifting mechanism to raise and lower the middle shelf. I decided to use 2 trailer jacks (Curt 28204) and 1/2" rod to connect them. This same design could be used to make an adjustable height desk.

No one part of this project was difficult, but everything took a little longer than expected. The end result seems very sturdy and is a good foundation to build a workbench/out feed table from.

Parts (Amazon Affiliate)
Bearing - http://amzn.to/29RcfrE
Gear - http://amzn.to/29RbMpu
Chain - http://amzn.to/29Rc9Ap
Rod - http://amzn.to/29Rcz9M

Sign up for monthly income, expenses, and net worth reports!
http://newsletter.mikeandlauren.com

Check out our blog:
http://www.mikeandlauren.com

Follow us:
http://twitter.com/mikeandlauren

Loading...

Advertisement
When autoplay is enabled, a suggested video will automatically play next.

Up next


to add this to Watch Later

Add to

Loading playlists...