 For the color with separate stand, we are going to draft first the color stand or band and Use the color stand as a base to draft the separate color This kind of color is usually seen on formal and casual button-up shirts and just like the previous color It can also be worn open or closed Same with the previous color. We need the back and front neckline measurements from our pattern blocks To start off get a piece of paper and fold it in half Square in a line at the bottom part of your paper From the folded line or center back mark in the half of your back neckline measurement and Square a line for the shoulder notch From the bottom line mark up the height of the stand which is 1 to 8 inches or 3 centimeters and Square a line From the shoulder line or notch mark in the half of the front neckline From the front neck mark mark up six-eighths of an inch or 1.8 centimeters From this mark draw a semi-curved line until the shoulder notch Measure this line check if the measurement is the same with your half neckline measurement and Mark in the correct measurement if it's incorrect from this mark draw a perpendicular line and This is the new center front and continue marking up the height of the stand and draw a curved line Next extend a line at the center front and mark out six-eighths of an inch or 1.8 centimeters for a button extension From the button extension draw a curved line upwards And now we have a color stand From center front line mark in two-eighths of an inch or 0.6 centimeter This mark is needed so that the color won't overlap and we are also going to use this mark to draft the color Next cut out the stand from the paper and Get the previous paper to draft the separate color From the color stand outline mark up one two-eighths inches or three centimeters Place the color stand at the mark upside down and Trace from center back until the mark near center front line and do not forget to mark the shoulder notch From the mark at center front line draw a 120-degree angle line like this one and Add the center back mark up two inches or five centimeters for the color height and Square in a continuous line and mark up four-eighths of an inch or 1.2 centimeters and From this mark draw a semi curve line until center back and cut out a separate color pattern from the paper and Now we have a separate color and this is the shirt color with the color stand or band So to adjust the color mark out one inch each side from the shoulder notch and square in the slash lines Slash the lines and spread each line by one-eighths of an inch or zero point three centimeter and Rejoot the color to smooth in the lines Voila, so this is the basic shirt color with the stand or band