Upload

Loading...

Fume Cabinet for Reprap Prusa Mendel 3D Printer

6,605

Loading...

Loading...

Transcript

The interactive transcript could not be loaded.

Loading...

Loading...

Rating is available when the video has been rented.
This feature is not available right now. Please try again later.
Published on Jul 8, 2012

This is a short run down on the Fume Cabinet I built for my 3D Printer.

I found printing with the window open insufficient for clearing the room of the printer fumes, as well as introducing warping to the prints on the print bed as the ambient temperature dropped.

I'd highly encourage anyone using their 3D Printer on the desk next to them to at least ensure that they have adequate ventilation, if not a fume extraction system.

Plus, it's a little quieter, and looks awesome with the LED strip lighting!

Remember to allow sufficient room around the printer not just for the moving parts, but also to access cables and parts that require adjustment, such as the end stops. Also, unlike a Makerbot, the build envelope of the Reprap Prusa Mendel isn't contained entirely within the framework of the printer. That is why I have such a steep angle on the screen on the front of my cabinet. With 25mm clearance at the front printer, I needed an 80° angle to clear the build envelope.

Loading...

When autoplay is enabled, a suggested video will automatically play next.

Up next


to add this to Watch Later

Add to

Loading playlists...