Loading...

Installation of a Trailer Brake Controller on a 2000 Jeep Grand Cherokee - etrailer.com

14,797 views

Loading...

Loading...

Transcript

The interactive transcript could not be loaded.

Loading...

Loading...

Rating is available when the video has been rented.
This feature is not available right now. Please try again later.
Published on Oct 3, 2012

http://www.etrailer.com/bc-2000_Jeep_...

Today on our 2000 Jeep Grand Cherokee Limited, well be installing the Curt TriFlex Brake Controller and the Universal Quick Plug Brake Harness, part numbers C51140 and C51516. Well also be using a wiring kit, part number 5505. Now, our Jeep Grand Cherokee is equipped with a factory 7-pole. Youll find a blue wire in the driver side kick panel labeled electric brake. This wire runs two of the factory 7-pole and it will be the wire that we'll use for the brake controller to run our brake feed. After locating that wire, well now need to run our battery positive and ground.

Note: Videos are provided as a guide only. Refer to manufacturer installation instructions and specs for complete information.

Loading...

When autoplay is enabled, a suggested video will automatically play next.

Up next


to add this to Watch Later

Add to

Loading playlists...