 I trimmed these a bit so it wouldn't hit the boat like half a centimeter of clearance. The size difference here matches up not close enough. I'll still need to put a tone thing on the end there at some point. Not super important though. Slapped this on the front the other day just so I could have a place to attach an anchor line and also if some other idiot crashes into the front of my boat I should be all right as long as it's not too big of an idiot. This is skinny mode for getting in and out of tight places and also with the pontoons all the way back like this they're a lot lower so they're taken up most of the weight so they lift the boat up higher and keep the propeller out of the muck because up here it's shallow. Where it is right now it's fine. If I just leave the two rear screws attached on this I can lift it enough to put things in there. I'm going to put my camera in there right now. Okay quick test of that propeller it's too high pitch and this is a high enough pitch that I know that I'd be able to keep up with the the motor when it's in there and still be able to like you know add something in but it's too high pitch to use on its own. Now I did make a second one of these with a lower pitch set of grooves so I think I'm going to take these blades out stuff them in this see how that goes. I'm going to go over there and do two runs. The first one is going to be leisurely paced like the kind of pace I feel like I could do all day like eight hours without dying and then the second time I'm going to go again I'm going to try to make it like like 10k running road race pace. It's like pretty fast but like something I could do for half an hour. Well that was nice fit that's what she said. I snapped a couple teeth off this gear here one right here and then yeah one right there. I'm pretty sure that happened when I was testing the propeller this morning that was too high pitch because I was I was cranking the pedals pretty hard to try to get it to go and I heard some crunching and I'm pretty sure that's what happened. So the test I just did now was with two teeth missing and still works all right. But I'm going to make a new one of those so I'm going to do a better job this time. When I did that first one I didn't get the teeth spaced as well as I should have so like two teeth are too close together and another teeth were too far apart not a huge amount but it makes a difference. I did a better job on this one probably because I was so anal and I did not want to have to replace this one. So since this one didn't quite fit I kept filing off more to make the teeth thinner so they'd fit because they weren't evenly spaced so if I make them evenly spaced I can make the teeth thicker. So I'll just have to do a good job on it. And of course not pedal super hard with a propeller that's too high pitch again. You know I kind of have to break these things sometimes to see when they break. All right I gotta get this whole thing apart now. Maybe I'll do it tomorrow. Yeah I'm not up for that today. So I think this propeller is pretty good. I'm going to go with this for a while. It's still fairly high pitch so it won't have a lot of drag even when it's not spinning. Anyway this might all change after I get the motorized one in.