 Ah, got him on there! It was actually really difficult getting the old propeller off here. It had only been there for like a, maybe a week and a half. But it was an aluminium propeller and it corroded and basically attached itself to the bolt that was holding it in. So I had to drill the bolt out. Luckily my pilot hole got right down the middle of the bolt so I was able to drill the bolt right out. Ah, got it out of there. But that also answers the question of why I don't just cast an aluminium propeller. I would definitely need to learn more about aluminium, aluminium alloys and sea water before I did something like a propeller. Alright, first I'm going to try just the pedals. Whoa, I can tell you already there's a significant improvement in some pedaling. I didn't break anything yet! I should have done that before. This is just pedals. It's pretty cloudy right now. That's what the solar panels are giving us right now. You know what helps with a solar panel boat a lot? It helps if you get the cover all the way off the solar panels. Because usually this is rolled up thing under here. It covers up the solar panels just to protect them when I'm not using the boat. Anyway, I came over to this side and rolled up most of the way off. But it was still on the top blocking like a strip of panels on the other side. Anyway, I fixed it now. So I should be getting even more speed. Not more speed than full batteries. But just more speed when I'm going just on solar. Repellers look good. No damage or anything. Excellent. I think I'm going to go to the store. It's like three miles away. I asked Isheina if she noticed the solar panel cover was still on the solar panels. And she's like, yeah, I thought that was weird. And I'm like, you didn't say anything for like 20 minutes while I'm driving. I was just getting worried about how windy it was. Then I was like, wait a minute. Let me stop. Yeah, half the wind was just for me going fast. Not that bad. It's getting a little windy though. I better get my butt home. Oh, new propellers are doing good. I like them. The motor seemed a little hot. Although it could just be that I'm overly sensitive to it because I'm testing and checking everything right now. But I'm going to want to keep an eye on that. I might want to shrink this propeller a little bit. I could make it lower pitch, but that would mean making a whole new propeller. Or I could just like trim a little off the ends of the fins. Just to make it a little easier on the motor. I don't know. I'll see. Test it a little more first to see how it goes. It could be totally within acceptable heat parameters for the motor. I don't know. Really, I could make both of these a little bit lower pitch. But yeah, I'm just going with this for a while. It's working for sure.