Cutting an Internal Keyway on a Lathe





Rating is available when the video has been rented.
This feature is not available right now. Please try again later.
Uploaded on Feb 4, 2011

This is one way to cut an internal keyway with a lathe. This is a good option if you need to make an internal keyway but do not have a broach set. In this video I cut a 3/16 square keyway in an aluminum bushing. I used a 1/2" internal boring bar with a 3/16 HSS tool bit set up in the QCTP. The carriage was used to move the tool bit in and out of the aluminum bushing until the desired dept was reached.

If you liked this video please rate and subscribe.

Music is royalty free from Dread Pirates.

Thanks -- TheManFromAlaska

  • Category

  • License

    • Standard YouTube License


When autoplay is enabled, a suggested video will automatically play next.

Up next

to add this to Watch Later

Add to

Loading playlists...