 cleanup and assembly of our hard plastic miniatures. Clippers and a scalpel always cut away from yourself as we're just going to take any little bit of plastic off. Just going to scrape the top of it off. We need super glue for this. Dry fit it first, a brush, and we damp it a little bit with some water. Put some water in the section that we're going to glue to, bit of glue on this, put it together, hold it there for a couple of seconds, a stuck miniature. The same with the arms and it's ready to go on his base. We're ready for priming. Hello everybody, welcome to another Mantic Quick Tip. We are doing today a cleanup and assembly of our hard plastic miniatures. These ones here, they come in a little bag, they've already been cut off the sprue for you, but you might notice that some of them do have a little bit of sprue still attached to them and we will need to clean that up. And we do this by two ways. We use our clippers and our scalpel. Be very, very careful with any of the knives. Always cut away from yourself. All we're doing and hence is we're just going to take any little bit of plastic off and anywhere that you have a piece of flash like this that goes along where the two parts of the model join together. I'm just going to scrape the top of it off very gently, making sure not to damage the miniature. And now for his other set of arms. There we go. And now for the main body himself. This guy has quite a lot of flash around his leg, so we get rid of that just by doing the same thing again, just by scraping along the model. Making sure not to put too much pressure on it, because you don't want to cut, we just want to scrape off the top layer and then we just have a little bit of sprue left here. Just going to gently cut off and there we go. And then we move on to assembling this guy. So now we're going to move on to assembling this little guy. We need super glue for this. It will only work with super glue. We want to dry fit it first to make sure that it fits okay. We've got the right parts as some of them do come with multiple different parts. We have multiple different arms that will only fit on one body. So you just match it up like a puzzle piece. Make sure it fits and then we've got all the right pieces. Now a handy little trick for doing super glue is we get a brush and we damp it a little bit with some water. Put some water in the section that we're going to glue to and then we put it carefully. Put a bit of glue on this. Make sure you don't glue your fingers to it. And then you put it together. Hold it there for a couple of seconds. The water will react with the super glue and start its curing process immediately. So we've got a stuck venture. Let's do the same with the arms and there we go. And with that the venture is fully glued and is ready to go on his base and ready for priming. And that's the end of this episode. Thank you very much for watching. If you liked it please drop us a like, subscribe and comment below. Let's know what you would like us to do. We will make sure that we will try to do as many videos as we possibly can. Thank you.