Loading...

setup bt devices with ease on arduino and ramps. bt_magic. bringing the magic back to arudino!

4,009 views

Loading...

Loading...

Transcript

The interactive transcript could not be loaded.

Loading...

Loading...

Rating is available when the video has been rented.
This feature is not available right now. Please try again later.
Published on Sep 19, 2013

basically setup bt device the way you would to run it with the jy-mcu module and load
http://www.reprap.org/wiki/Jy-mcu

this code onto arduino. bt baud rate is auto detected, and a menu is activated in the serial monitor of arduino ide so you can set and make changes on the fly. setup bt device id name, change baud rate and, and pin all within a minute! also reports firmware status. program is working, but it is first version. should work ok! tested!

  • Category

  • License

    • Standard YouTube License

Loading...

When autoplay is enabled, a suggested video will automatically play next.

Up next


to add this to Watch Later

Add to

Loading playlists...