 Give a brief demonstration and introduction to the RE524X or universal wireless to wireless translator. Start off by adding the 12 volt power supply. And with the battery already connected, I will have both LEDs at the top come on solid. Next I want to choose the appropriate sensor type that I want the translator to listen for by changing the dial. And then I can also change the panel selector switch to the panel I'm using on this install. Then I want to engage the enroll button. And by tripping a sensor, I'll now see the LED at the top flicker indicating the translator is hearing that sensor. And the second LED will flicker once it's transmitting that sensor signal back to the panel. Once I've completed the enrollment, I'll want to take the translator out of enrollment mode. On the left hand side, there is a sticker indicating the identification to enroll the translator into each panel. And a great new feature of the translator line here, if I choose the sensor type and the panel type to be the same, this will now function as a repeater and this is supported on every panel type that we support. Lastly, I'll go over the lock function of the translator. This will keep the translator in the current settings that it has. Be sure to go over the manual for additional features of this because this cannot be undone. Make sure to subscribe to our YouTube page and click the Show More tab underneath the video where you can view valuable links pertaining to this product, similar how-to videos, and our low-cost, no-contract alarm monitoring services.