 Welcome to the Argos assembly guide for adult cycles equipped with disc brakes. This video guides you through the basic steps in assembling your Argos cycle. For this cycle, we recommend allowing 60 minutes for completion. This cycle has been rated a level 3 difficulty. Some help may be required. There may be some slight variations between the cycle assembled here and the cycle you have. This is OK as the procedure is the same. Remember to stay safe and legal with lights, cycle helmet, lock and many more accessories available at Argos now. Unboxing the cycle. Remove the seat and accessories from the box. Take extra care when lifting. When ready, remove the cycle from the box. Help may be required. Start removing the protective packaging. Use scissors to cut the cable ties where necessary. Open the kit box or bag containing the pedals, tools and all the accessories required to assemble the cycle. Attaching the handlebars. When attaching the handlebars, first check the quill nut is loose which is located at the bottom of the handlebar stem. If not, use the allen key provided to loosen the quill bolt by turning it anti-clockwise. Make sure the gear and brake cables are not twisted around the frame. Make sure that the front forks are facing the correct way by ensuring the bridge is facing forwards. Check that the front forks, frame and handlebars are correctly aligned before inserting the handlebars. When the handlebars have been inserted, remember to check that they do not exceed the maximum height mark. Finally, tighten the quill bolt to secure the handlebars in place. Attaching the rear reflector. Some rear reflectors come fitted already. If yours does not, you will have to attach it before fitting the saddle in place. Slide the reflector onto the saddle post and tighten the screw to secure it in place. Inserting the saddle. Align the saddle post with the bike frame. Insert the saddle post to the desired height. Remember to pay close attention to the minimum and maximum height marks. Tighten the seat clamp bolt with the allen key provided to hold the saddle in place. Attaching the wheel. Fitting the front wheel is easier with the cycle upside down. Some assistance may be required. Firstly, remove the axle protector caps by pulling them off, not turning them. This will prevent the wheel nut from getting stuck in the cap. When ready, insert the wheel so the axle is located at the base of the forks. Now that the wheel is in place, move the retention washer to the base of the forks and tighten the outer wheel nut with the spanner provided. Attaching the pedals. Firstly, unwrap the pedals. Note the left and right markings. The right hand pedal always attaches to the side with the chain. Screw the right pedal clockwise and tighten with the spanner. When fitting the left hand pedal, remember to screw anti-clockwise. Attaching the bell and front reflector. The bell and front reflector may also need attaching to the cycle. Starting with the front reflector, loosen the screw and attach to the handlebars. Once attached, tighten the screw to keep the reflector in place. Follow this same procedure for attaching the bell, but place on the left near the hand grip for comfortable operation. Inflating the tyres. Use a pump to inflate the tyres. Check the tyres are inflated to the correct pressure. The recommended pressure will be located on the wall of the tyre. Pre-ride checks. Before riding your new cycle for the first time, let's do some pre-ride checks. Check the saddle is secure by twisting it left and right. Spin the wheel to make sure there's no side-to-side movement. Make sure there's no excess play in the wheel hubs by moving the wheel left to right. Check the pedals are fully secure using the spanner provided. Check the brakes are operating correctly. Make sure the handlebars are tight and are turning with the wheel. Assembly complete. Congratulations, you now know the correct procedure to assemble your new cycle. Remember to take extra care on your first ride.