Get a 1 year subscription for only $19.95 from ALLDATAdiy! Use Code DIYDISCOUNT.
Click here now! https://fxo.co/1170629/fixitangel1
https://tinyurl.com/yyx4fa92 https://www.amazon.com/shop/fixitangel i get a commission on products purchased through links in my video description
1996 1997 1998 1999 2000 2001 2002 Toyota 4Runner, V6 engine.
**NOTE**The container with the new fluid, the cap has a hole on it. LOOK AGAIN!!
2001 Toyota 4Runner. Doing a transmission flush, using a 12 volt oil pump I bought from Ebay.
Dexron III https://goo.gl/aw2wAT https://goo.gl/29bPpt
Oil Funnel https://amzn.to/2JzuQ2A http://tiny.cc/lezd4y
12 Volt Transfer Oil Pump https://goo.gl/K6ccYz http://tiny.cc/o05d5y
5 Gallon Plastic Jug https://amzn.to/2UKzpwe http://tiny.cc/ib6d5y
10mm ID clear tubing hose https://amzn.to/2VSjGrr http://tiny.cc/sy6d5y
Hose Clamp Pliers Set https://goo.gl/q9Bu4o https://goo.gl/w6rdyf
Long Needle Nose Plier Set https://goo.gl/E8T1u4 https://goo.gl/ReKkqe
Pliers https://goo.gl/wBSjlw https://goo.gl/XK5qpX
Battery Jump Box https://goo.gl/pPQL9Z https://goo.gl/NtCzKE
Shop Towels https://goo.gl/K1LJKh https://goo.gl/aeqBTL
Shop Rags https://goo.gl/wzFLHT https://goo.gl/C6UfjR
Long Funnel Set https://amzn.to/2Fi8n4G https://goo.gl/B8xFYG
I got the containers from the Toyota Detailers when I used to work there.
You can go to any Car Detailer shop and ask for the empty ones. Most just throw them away.
PLEASE READ WHY MY METHOD WORKS:
The tranny pump sucks oil from the pan and pushed oil to the cooler. On the return the oil is dumped into the pan, not sucked into the pan. This is why the gravity feed did not work so good.
There is no force that is sucking the fluid back into the transmission. It is all being pushed into the transmission. By removing the push part by disconnecting the transmission out line into a old fluid bucket, I have to use a pump to replace that push pressure, which this video is showing by pushing the new fluid.
Transmission pushes out to cooler, cooler keeps getting pushed back to transmission
Transmission push out to bucket /continuity broken/ From new fluid bucket, there is none (or not enough) gravity assist pressure to cooler thus nothing going back to transmission.
Transmission push out to bucket /continuity broken/push new fluid to cooler via pump, keeps getting pushed back to transmission
The information contained in this video is for general guidance, not responsible for any errors or injuries that you have done. Samsung W200 pocket camcorder was used to do this video.
Please subscribe and thank you for watching. Follow me on TWITTER: @88bmyvegas and http://lasvegasautoinsider.blogspot.com/ DISCLAIMER - Due to factors beyond the control of FixitAngel, it cannot guarantee against unauthorized modifications of this information, or improper use of this information. FixitAngel assumes no liability for property damage or injury incurred as a result of any of the information contained in this video. FixitAngel recommends safe practices when working with power tools, automotive lifts, lifting tools, jack stands, electrical equipment, blunt instruments, chemicals, lubricants, or any other tools or equipment seen or implied in this video. Due to factors beyond the control of FixitAngel, no information contained in this video shall create any express or implied warranty or guarantee of any particular result. Any injury, damage or loss that may result from improper use of these tools, equipment, or the information contained in this video is the sole responsibility of the end user and not FixitAngel nor any of it’s subsidiaries.