 Hello everyone, okay, so in this video I'm going to show you how to replace the smartwatch EX16 How to replace the battery? so all of you might think how to to remove this watch strap This is not the LN key. This one is just a pen So you need to remove it using pliers Yeah, it's very simple. You just clip it If you like this And you just pull it over pull it off You do that on all four Corners and you will be able to remove the wrist wristband and then later you can remove the Screws at the back here. So I'm going to do that first So as you can see I already removed one here You can see this is just a pen not even a screw so I'm going to do do that for the rest of the pen over here Okay, now you can see that I I Managed to remove all of it all of the pin and now I can access the back screw on the back of the watch So I'm going to replace the battery which is CR2032 Which is three volt. Yeah, I'm going to replace the battery at the back By removing this small screw Okay, now I already removed the Four screw at the back and I can remove this piece the back piece Move it aside and you can see Did that this is the battery. So it uses this CR2032 battery, which is three volt as I mentioned before so I'm going to replace This battery to this one. I'm going to replace the new one So the reason why I want to replace this battery is because Even though you can see this turn on whenever I press the light button You can see it's getting dim so that shows that your battery is getting low So you need to replace the battery to Give it a new life Yeah Okay, so to remove the battery. It's very simple You don't have to remove any of these mini screw at the back. All you need to do is take the SIM card remover from any kind of smartphone that you have and just Push it in in the hole and you just lift it up. There you go. You can remove the battery now Okay, here is the old battery So I'm going to replace it with the new one. So I will put this aside. I'll throw this away in a rubbish bin And this one is new one as you can see so I'm going to put it on its original place and Press it down like this And make sure it clips right there make sure it clips on its place Just like that and you are ready to go. So I think it's yeah, there you go. You can see it's turned on So put everything back together Put everything back together and Yeah, that's it. So If you enjoy watching my video, please Give it thumbs up leave a comment and don't forget to subscribe. Thanks. Watch. Thanks for watching guys Have a good day