 Well, we need some voltage so let's move that out of the way. I can probably do getting that off my bench I do have a bit of a strict rule actually about having drinks in here Because it's the only place really that you can cause a way of mischief mayhem by screwing them So, but I can't really look at three volts isn't it so I'm going to plug this into my five volts part of my power supply Which means no matter what happens the worst I can do is give it five volts But it is set to three volts and I've set it to 80 milliamp We just need to connect the speaker So we can just Disconnect from my little amplifier over here my little home ground Which is quite sweet actually I've got panasonic capacitors on it and all sorts and it does sound quite nice And I do actually get you know pretty much 15 watts out of it Had the voltage because my power supply here has got a it tells me what power I'm using what wattage I'm using as well So we can see when it's drawing the power What power I'm actually giving the circuit Now comes in hoodie handy I don't know why I just made that So we're going to need a little bit of a farrowy core finger in here Because I noticed with the other one If you don't put it in you're not actually getting anywhere Oh At least this one goes in the other one was a right pain, but I did get an eventually Okay, so problems when I put the power on there We should have some sort of life. Okay, if I can get these Clockadall clips, which I'll tell you what, you know, I don't know. It's me and my circuits I do ask a lot from these clips on these things Especially when I'm checking them on to my capacitor banks and stuff and hitting the tesla club Uh Right, let's shift them out the way I have a little bit of a It's all ideal And then we're gonna hit the power. So let's hit the power Okay, he's not drawing anything because the thing's not switched on so let's switch it on It's drawing it says uh 0.7 Uh, but the level yeah, yeah, yeah 0.007 But we're not hearing anything. So let's just do a bit of that Turn it up full blast I'm not hearing anything Oh, I know why I forgot now that's something about these kits. Let's turn it off That's something On the other side, let's take this back off again On the other side of here There are some Little areas Which for some reason you have to bridge and within the instructions, of course It's very hard to see anything about that because it's all in Mandarin And I through my ignorance do not read magnet Mandarin So but Here you have the bridge one two three Let's get this light across there Because it looks like we're left something out there as well. What about if that there? Oh the LED So we're going to put that in one two three four and there's four little tiny bridges So we're not connected to anything there either, are we? So where's that little LED? Now the thing about the LED Is it needs to be on this side. So we're going to make sure we get the polarity, right? And the polarity there is going to be positive There so we want positive here And negative there now I don't know how far to stick this out. So I'm just going to do it like that I'm going to solve it because we have to have it soldered And I'm going to do the And I'm going to do the other thing Do them little jumpers, but just to save time here. I'm just going to do We've got the little LEDs on the go That lights up That's not a problem Let's see the LED lit up But we don't seem to have any wobbling I was just looking on the back to see The connections here I don't seem to like it because this wire is very very thin And just connecting to it. This gives you the impression that it's actually got a little life in it Okay, so that's better But we don't seem to be able to get the station Or any sort of Real output sound So that's off That's all the way on it doesn't go any further But no no volume I'm just having a look on the back to make sure that everything Oh, let's get that off Here's connected as it should be we do have an issue with the connection here. That's what you can hear the popping sound but Everything on the back here looks fine Now I know this one works if this doesn't tune in we've got a lot of sound with this one So I'm going to do is I'm just going to compare a couple of bits on the back here Just to make sure Everything that's correct and in order Yeah, so possibly Possibly I've got the area all the wrong way around So what we're going to do is just just turn it off here I don't know if I'm just double check this aerial Because this is the same sort of symptoms as I was getting sd and you know, I've done the same thing again I think it's It's a close one to call, but I think that should be on b and it's on c now that will cause this To not have any volume So it seems like I need to change these two around because As the wires come round, it's only one strand difference and so it is easy to make that mistake So that's what we need to do. We need to take that out b and c And swap those around and then I think we're on to a winner So let me just Knit those up and I'm going to do this Is to stop me from wanting to turn it over and I am not going to check just checking this recording there. So I'm going to turn it over I'm just going to move that one out the way there and I'm going to pop this on this side It's exactly the same as what I did to the other one Okay That one on to b And I think Switch that down I think we now have a bit of a winner. So let's switch it on Tell me about nothing. That's what it's called for, isn't it? That's That would be absolutely fine. I'm pretty confident they're in the right places Could that be wrong? I don't think that would matter anyway if it was But no, that looks Looks like it's in the correct places So I can't see anything wrong with the aerial side of things We still got power coming through, but there's just no amplification It doesn't seem to be So do you know what I'm going to do? I'm going to take this tuning capacitor off here I'm going to pop it onto the other one and see if we can get See if we can get anything better out of that Okie dokie, right. Well, a little bit of perseverance and You know we had Two of these Two of these boards And this one I put together last night and couldn't get Anything out of it whatsoever Nothing audible anyway, audible. It was registering that it was using a bit of current draw But it wasn't actually giving us any Audio output So today I thought I'd have another little play with this because it had an audio output And I played and played and I don't know how long I've put into this playing with those cans for three hours Uh-huh Um, it's okay. I'm not being kept from anything. I don't actually have a life So I ended up thinking well, I've played and played with these and I noticed that these ones all seem to be right set pretty much at the top So I thought oh, I bet they don't bloody work either And so now I popped them on Um And with very little help With very little help I managed to get a I take this light off I got my favorite radio station I think I'll have a little dance later But seriously The actual capacitor is really sensitive I didn't check it I didn't check it to see what the capacitance was actually across it Maybe I should have done I just gotta check I've got a laptop I'm fixing I just gotta check it I'm installing fedora and sometimes when you leave it and it goes into standby in the middle of Um, installing it you have to restart the thing Yeah, one player kicks the ball Another player gets it and kicks the ball Somebody else gets the ball and kicks it There's only two people allowed to pick the ball up though, three people It is worrying in times, isn't it for the world of football Okay, okay, maybe I'll just run in trouble Then I'm going to have to worry about your stupid train There's not that Like much for the old music stations Maybe that's a good thing because we don't want, you know YouTube, Google, whatever Getting all upset and distressed that somebody might be making a buck off something It's all the football There's music It's all just football And like it works there you go. So anybody wants to build one of these kits. Yeah, they do work you Might have a little bit of faffing about to do good. Um You might end up with a few spare parts maybe but it works Yay