Loading...

Commissioning the CMMP-AS with PROFINET: Parameterising FPC

1,437 views

Loading...

Loading...

Transcript

The interactive transcript could not be loaded.

Loading...

Rating is available when the video has been rented.
This feature is not available right now. Please try again later.
Published on Feb 6, 2018

Commission the controller CMMP-AS with PROFINET – this tutorial explains how to parameterise FPC optionally.
Commission, configure, convert or repair Festo products quickly and easily with videos from service2see.

00:52 Activating the parameter channel in the Festo Configuration Tool

Activating the FPC block in the Siemens TIA portal
02:16 - Activate hardware module
02:48 - Create block
03:55 - Link blocks

05:40 Reading parameters via FPC block, using the example base velocity

Comments are turned off
to add this to Watch Later

Add to

Loading playlists...