Loading...

Laser cutting crowns from poster board

555 views

Loading...

Loading...

Loading...

Rating is available when the video has been rented.
This feature is not available right now. Please try again later.
Published on Jan 2, 2014

Laser cut poster board using a 50 watt CO2 laser from Epilog Laser. Setting on this were

Speed: 100%
Power: 45%
Frequency: 500Hz

I probably overdid it on the power a little bit, but I didn't want to waste too much time fiddling with settings. It's not like I could get it to go any faster than 100% speed.

Loading...

When autoplay is enabled, a suggested video will automatically play next.

Up next


to add this to Watch Later

Add to

Loading playlists...