Upload

Loading...

Jeep Liberty Window Regulator

59,850 views

Loading...

Loading...

Transcript

The interactive transcript could not be loaded.

Loading...

Loading...

Rating is available when the video has been rented.
This feature is not available right now. Please try again later.
Uploaded on Apr 13, 2010

In this how to video, you will be shown the basic steps in how to remove a Jeep Liberty power window regulator and motor. Step one, remove the phillips screws on the arm rest and at the door latch behind the snap in cover. Do not pull on the arm rest or it will break, it is part of the door panel. Step two, start at the bottom of the door panel and pull the at retainer points outward. GET A TOOL! These retainers are $5.00 each at the dealer. You can do the job with a flat scraper like I did, just be careful. Use a rag or something to protect the paint on the inner door and panel. Step three, remove the speaker and unplug the window motor wires. Step four, pull the protective plastic back and loosen all mount bolts. Step five, raise the window and bring the regulator out of the large hole. Reverse procedures to install. Do not kink the new plactic cable housing during the install. Let me know if this video helps.

Loading...

When autoplay is enabled, a suggested video will automatically play next.

Up next


to add this to Watch Later

Add to

Loading playlists...