Loading...

TRS-80 Model III with SD HxC floppy emulator

3,420 views

Loading...

Loading...

Rating is available when the video has been rented.
This feature is not available right now. Please try again later.
Published on Jul 7, 2013

A demo of the HxC (http://hxc2001.com) SD floppy emulator rev C (cased) connected to a TRS-80 Model III.

I've connected it to the external floppy port, although it can also be connected to the internal floppy port which would allow booting from the emulator.

The TRS-80 drives are normally numbered as follows:
:0 = first internal drive
:1 = second internal drive
:2 = first external drive
:3 = second external drive

A normal straight-through (untwisted) ribbon cable was used between the TRS-80 and HxC. Make sure you plug the cable the right way into the TRS-80 and HxC -- experimentation may be required.

Use the standard Shugart jumper settings on the HxC, i.e. a jumper on ID0 for "Drive A" and a jumper on ID1 for "Drive B". Do *not* use ID2 or ID3 regardless of whether you're connecting it to the internal or external floppy port.

Note: HxC firmware V1.8.2.20a or later is required to change drive B disks on the TRS-80.

If you'd like to discuss this video, please visit the HxC forums at: http://torlus.com/floppy/forum/

Comments are disabled for this video.
When autoplay is enabled, a suggested video will automatically play next.

Up next


to add this to Watch Later

Add to

Loading playlists...