 All right, let's set up your sink thing. So power goes in the bottom here, you've got your mic input. So what you do is you get your beautiful MP75 that came in the box, clip it in, you get your XLR cable and that goes in there. I like to do a little bit of a wrap and that goes into the mic and then there's a slot there for guitar, which we have here and you'll notice there's another input for switch and that's referencing either our switch 3 or our switch 6. These are great. They basically, you can assign any of the effects from the sink thing to correspond with any of these switches. So if you're playing guitar while you're singing but you want to trigger some harmonies or some delay, you can program that to one of these switches and do it with your feet instead of your hands. Just make sure that you are using a TRS cable which comes with them in the box. TRS is tip ring sleeve, you'll notice there's two bands across the input jack there. So that's TRS as opposed to TS which is a standard guitar cable. So next, we've got an AUX input, so that's this cable. If you were to hook up a phone or anything, you would do that there and then you have your output. So the output is going to be going to your mixer or if you have an interface for your computer, you want to do some recording, you use that XLR out. There's also a MIDI input. If you have a MIDI controller or anything that you want to be sending MIDI signals or keyboard that goes there and then we've got our USB input here for doing those firmware updates or getting some more presets for your sink thing. So that's all I need. I'll actually probably plug in our switches here as well. So I think I'm going to use probably just the switch three today. This little guy. There we go. All set up.