GB

InventorCAM iMachining Training Course - Exer #3: Define the Tool for the CAM Project

SolidCAM iMachining
10K
718 views

Transcript

The interactive transcript could not be loaded.
Rating is available when the video has been rented.
This feature is not available right now. Please try again later.
Published on Apr 18, 2014

After loading the CAM-Part (Step 1), this video is Step 2 in Exercise #3 of the Interactive Training Course for iMachining. The following actions are implemented to define a tool suitable for the CAM Project. The defined tool has a 12 mm (0.5 in) Diameter, 24 mm (1 in) Cutting length, 5 flutes and a 45 degree Helical Angle. All iMachining operations in this exercise will use this same tool.

When autoplay is enabled, a suggested video will automatically play next.

Up next

to add this to Watch Later

Add to