 Hey guys, Drew with GeoArm and I'm back to talk to you about the M2M MQ03-LTE and it's wiring into the GE InterLogix Networks panel. Super easy to do, four total connections. Prior to doing this, of course make sure that your panel is completely powered down, unplug the backup battery and the power supply, make sure that it's dead, you don't want to, you know, fry this panel. So it's not going to hurt you, but it will fry the panel for sure. So make sure it's powered down. In my case it's definitely powered down, this is a shell, so I've already done that. So and on this communicator you're just going to go ahead and take a look at the connections real quick here so you can see I've pre-wired this. So you're going to see red going to positive here, black going to negative here. Those are going to be our two connections for power. Then you're going to have a red going to ring and a black going to tip. Okay, that's the way that this communicator is wired right now. So we're going to go ahead and get this wired back to the panel now and what we're going to do is we're going to go ahead and wire it into the pause and calm of the panel itself. So you're going to find pause and calm on the networks. Red is going to go to pause and there probably will be other wires in here. It's perfectly fine. This is going to go in there along with it. Just make sure that you get all those other connections put back in here if they do fall out. Then black goes to calm. After you've wired that in, the next connections we're going to make here are going to be for the communications. So down in the very end down here if you see T1, TR and R1, if there's any wires going into those four terminals go ahead and get them out. These are the only two wires that are going to be going down. So at this point you're going to take the black wire and you're just going to be running to T. The red wire is going to be going to R. Once you've done this, this device is ready to have its antenna connected, which as you can see right here just connects like so, and it's a cool antenna because it's magnetized so it can stick right on top of the panel or on the side of the panel. Now at this moment we are ready to have our internet connected. As you can see the ethernet connection is right there. So we just take our ethernet cable and we plug it in like so. At this point we are ready for internet and we are ready to have this thing activated. Go ahead and power the panel on and then give us a call. Thank you guys for watching. Any questions or comments please leave them below. Take care. Make sure to subscribe to our YouTube page and click the show more tab underneath the video where you can view valuable links pertaining to this product, similar how-to videos, and our low-cost no-contract alarm monitoring services.