 I feel so bad for this screwdriver. I'm gonna have to stop using it to put the propeller on the boat and take it off Because it keeps going in and out of the saltwater and I take it out and rinse it off and oil it But it's still getting rusty. So I'm gonna make a stainless screwdriver Maybe it's another maybe I wonder what you these is harder Well, I already cut the end of this bolt Maybe I can just Put the X right into there this screw is the same size thingy as my propeller screws. Oh Beauty nice, that's pretty good. I think I have an idea for touch-ups Let's take that Hammered in there a little bit. Oh, it's not gonna get much better than that All right, I need a little handle for this guy Okay, we can handle out of that. It's already got a hole Some of that gorilla glue would do it if at some point this part starts slipping I'll drill a hole through the side and put a pin in I'll see how it goes without it though. So this here is the fat Phillips size Maybe I should do another one at the other end The Phillips this the number two. This is a number three Brune number two on this end. Hmm. Yes, I may as well That's like some kind of black belt grinder ninja in here or something. Oh Pretty good, I won't rest though. Yeah, don't touch the the glue there in there Think that'll be good for the boat Has the two different sizes of screws on the boat This is for the propeller and this is for there's one thing that I occasionally need to tighten that uses that size