Loading...

Keeping your 3D printer filament dry, the easy way

4,530 views

Loading...

Loading...

Loading...

Rating is available when the video has been rented.
This feature is not available right now. Please try again later.
Published on Jul 18, 2014

Required materials per storage container:
A clean bucket - anything from 3.5-7 gallon works
Gamma Seal Lid: http://www.leevalley.com/en/garden/pa...
SIlica Gel Dehumidifier: http://www.leevalley.com/en/wood/page...
5cm of hook and loop tape (e.g. Velcro)
Your 3D Printer filament
Total container cost: about $25

1. Spin ring off of Gamma Seal lid. Place on top of bucket. Invert and apply mallet or foot until well seated.
2. Attach dehumidifier to lid using strip of hook and loop tape.
3. Place spools of filament into bucket
4. Spin on lid.

So easy!

Loading...

When autoplay is enabled, a suggested video will automatically play next.

Up next


to add this to Watch Later

Add to

Loading playlists...