 That's gonna be my rudder. I already glued a tube onto it. I didn't have my camera out the other day when I did this. But this I just wrapped fiberglass around a steel tube that was waxed and had some paper on it just to give it a bit of thickness before the fiberglass. So this should fit in without being too tight. Yeah, hinged kind of like that. This is divided into five pieces and two go to here and the other three go to the other piece. That sounds good, I don't know. There, the two are a little bit longer than the three. So I should even up, okay. I'll leave those two attached and put these three on the other side. It's a little tight. Good thing I put a paper layer in there. Alright, I think I got it lined up. I just need to put a bit of resin on those to hold them in place before I get some fiberglass on there. Two layers of fiberglass on that. Hopefully that's enough. I got these guys double layered on too. And I did remember to put a little spacer between the the piece and the boat so you know I don't have to cut out any of the boat to get this to fit in there. Yeah, those are strong. A couple of washers in there will keep this part from wearing through this part. Those were lock washers, but I bent them so they're flat. Hopefully that's above where the water will be. If not, at least it's streamlined. Stop and you forget your lineup, whatever, your measurements. The thing here, your Z-axis is on 70. Turn it one, two, three, four turns back to 70 and then make your cut to 90 to make the groove a little bit fatter. Alright, then one, four turns back to 70 and keep going. I've been trying to wear this hole big enough for this pipe for like ten minutes. Man, the stuff is tough. It's very encouraging to know that even when trying to wear the material with sandpaper and stuff that will wear it, it still takes a lot of effort. So hopefully it'll last a long time when it's out there in the boat. This is the first thing I made on my little lathe there. It's been sitting on my desk thinking it wasn't ever gonna get a job, but now it's getting a really cool job. I think this is ready to install. Excellent stuff. Put something here to just hold this in a couple spots.