 Hey guys Drew with GeoArm and I am back to talk to you about the M2M MQ03-LTE-FIRE and how to get that device wired into your FIRE panel. Now before I get started on this I do need to preface this with this is not something you want to do yourself. You want to have a FIRE technician do this or somebody that's trained in high voltage specifically but a FIRE technician will be able to do this for you with no problem. So for the end user you don't want to do this yourself make sure you get a FIRE tech. For the FIRE techs watching this video we'll go ahead and proceed further. Make sure the panel is powered down. No batteries, no power, you unplug the power supply as you can see my panel is dead here we're not working on a live panel. Now what I'm going to do is I'm going to show you the M2M communicator. This communicator I've pre-wired it does not come this way. You will need some strips of 22 gauge, 20 gauge, 18 gauge wire. I'm using 22, 2, just 3 different strands and I'm sorry it's confusing here with the black and red but that's the only strands I had at the moment. So what I'll do here is I'll go ahead and I'll show you guys how to get this wire directly into the panel. So we'll go and verify the wiring here. The first strand is going to be the positive and the negative for power. So we'll have red to positive, black to negative. Then for the second and third strand this is going to be for communications. You're going to need to have two going back to the panel as required by fire panels. So we have a red going to ring, a black going to tip. Then we have a red going to ring two and a black going to tip two. Once you verify that these connections have been made here we're going to go ahead and we're going to proceed on to getting it wired into the panel. So I'll put this over to the side here and we'll get power wired in first. So power, we're going to go our red and black from power and we'll go black down here. Get it in place and then get it screwed down and tightened in place. Okay, that's ready. Now we go to the red one, get that in place, get it tightened down. Now once that's been done we're going to grab our first tip and ring wires which are here and we're going to wire those in. So we're going to go red to the first ring here. And then we're going to go black to the first tip here. Okay, once those are in place you're going to grab your second tip and ring wires. And you're going to be going red to ring which is here. And you're going to be going black to tip which is located directly next to it. Go ahead and get that in place and tighten down. Now I didn't feed these through knockouts or anything like that. You're probably going to do that. I just showed you how to wire it straight up. But once you've had these connections made, you're ready. This thing is connected. Now you just need to get your antenna put in place which you can do like so. Super easy, just screw it on there, tighten it in place. Now this antenna is magnetic. You can put it outside the box and it'll stick. And the last thing we have to do here is we just have to get the internet plugged in which you're going to do right here by snapping the internet in place like so. Once that's done, this device is ready to be activated. You can power your panel back on and you can give us a call for activation. If you have any questions, comments, anything at all, please leave it below. You guys take care and have a great day. Make sure to subscribe to our YouTube page and click the Show More tab underneath the video where you can view valuable links pertaining to this product, similar how-to videos, and our low-cost, no-contract alarm monitoring services.