 Welcome back as promised. We're now going to finish off this table leg by adding a little bevel to it So first thing I'm going to do just to make life a little bit easier is To just move this out of the way of the table so we can see everything and the trick to this The reason that this step exists at all is because I want to show you how to select edge loops, which is really important So we're going to go into edge mode So I just right click on my shape and select edge like so and you can see that whilst I'm doing that I can click and select on any edge and that will select it What I can also do is if I hold shift on my keyboard and left click it will allow me to select multiple edges That can take a long time though So what I'm going to do instead is use a couple of methods to select all the edges that I want So to select an edge loop what you need to do is find any edge that's facing the direction You want and double click it And you can see that's now all gone kind of pinky orange whatever that color is And that means that that entire edge loop is selected Then what I'll do is just swing around to the other side I'm going to hold shift on my keyboard while I do this and double click again We've now got both those edge loops and I'm just going to double click there to get that one And double click there to get that one I've now got all four corners just to keep this even and make the topology makes sense I'm also going to keep holding shift and set the two top edges And the two bottom edges That means that I've now got the front ring selected all the way around and also the one the back So this double clicking to select edge loops can save you a lot of time. So remember that Okay, what we'll now do is just add a bevel to this and this time I'm going to do that by using control and b on my keyboard. So control b There is my bevel beautiful little bevel and I'm going to drop the fraction on this to 0.2 I think will look nice Yep, that's nice enough. So we'll go back into object mode on our table leg And I'm just going to drop it back into place for now or roughly where I think it's going to be That's pretty nice. So we've now got our table leg done and it's beveled The last thing for us to do really is to add this to a layer So that we can hide it while we're working on other things So we'll do that by getting a marquee selection of everything that we're looking at down into our display panel down here where we can get layers Create layer from selected Give it a name. So I'm going to call it furniture. I think And save and that means that I now have the ability to toggle that on and off Okay, the next step We're just going to have a real quick look at what extrusion is before we go on to do some for ourselves So I'll see you in the next step for that Game Dev Academy is graciously supported by these absolute legends If you'd like to offer your support then check out our patreon page using the link in the description below