 Hello everyone today. We have a lamp and outside lamp We're going to take it out of the package. We have some hardware and some wire nuts or fasteners. We have the shade This is rust resistant because it's metal. It's made to be outside although you can put this inside And we have our gooseneck Now this light has a sensor on top of it So when it gets dark out it will automatically turn on and when it gets daylight out It will automatically shut itself off The first thing we're going to do is take our old light down and it goes without saying make sure you have the power off Now we want to unhook our wire nuts Next we're going to take our old mount off Because the one we're putting up comes with its own hardware as you can see This wasn't put in right Whoever put it in last so I'm going to drill two new holes and put it in properly. So I'm going to hold my base plate up here And I'm going to mark two holes and that's where we're going to put our anchors Now we're going to tap our anchors in And the good thing about this plate is it's very versatile Or you can put your screws if you didn't get your holes perfectly you can change them later by adjusting them Now we're going to hook up our wires. They are color-coded white to white black to black and copper to copper Now we're going to put the gooseneck on make sure your wires up here out of the way Where they can't be pinched Line your two studs up with the two holes on the base And put on your two supplied cap nuts You don't have to tighten these with a pair of pliers all they have to be is finger tight Now we're going to put our lampshade on And you just take off this white collar nut Put your shade on Put the collar nut back on again. No pliers needed And that just screws in just like a regular bulb. I have the switch on I'm going to cover the sensor up And as you can see it comes on and it goes out when there's light There it is as you can see it start time out. That's what it looks like at night time