Loading...

Cutting slats for my CNC water table (Torchmate 2x4)

4,765 views

Loading...

Loading...

Loading...

Rating is available when the video has been rented.
This feature is not available right now. Please try again later.
Published on Mar 2, 2011

Hypertherm Powermax 1250 G3 with machine torch cutting out slat holders for the water table for the CNC plasma machine. 1/4 inch plate running at about 85 inches per minute at 65 amps.

@gzmpepe

Slat hoder DXF can be downloaded here: http://theharmonfam.com/download/torc...

I have a 4" deep water tray. The longer one is for the center section (reverse it compared to the outside). The allowed me to put a bow in my 1/8" x 3" slats to reduce vibration and make sure my lines weren't straight (in case I happened to cut a line directly over a slat (meaning parallel to the slat, but directly over it)--which has happened).

Loading...

Advertisement
When autoplay is enabled, a suggested video will automatically play next.

Up next


to add this to Watch Later

Add to

Loading playlists...